This is an outdated version published on 06-03-2026. Read the most recent version.

Determination of Pinaverium Bromide in pharmaceutical dosage forms by a validated Stability-Indicating LC Method

Authors

  • Maximiliano da Silva Sangoi Laboratory of Pharmaceutical Analysis; Faculty of Pharmacy; Federal University of Rio de Janeiro
    • Anna Karolina Mouzer da Silva Machado Laboratory of Pharmaceutical Analysis; Faculty of Pharmacy; Federal University of Rio de Janeiro
      • Lorena Coimbra Florindo Laboratory of Pharmaceutical Analysis; Faculty of Pharmacy; Federal University of Rio de Janeiro
        • Brenda Rocha Gonçalves Laboratory of Pharmaceutical Analysis; Faculty of Pharmacy; Federal University of Rio de Janeiro
          • Vítor Todeschini Laboratory of Pharmaceutical Analysis; Faculty of Pharmacy; Federal University of Rio de Janeiro

            DOI:

            https://doi.org/10.22456/2527-2616.73964

            Keywords:

            pinaverium bromide, experimental design, liquid chromatography, stability-indicating method, validation

            Abstract

            A reversed-phase liquid chromatography (LC) method is validated for the determination of pinaverium bromide (PB) in pharmaceutical dosage forms. The LC method is carried out on a reversed-phase monolithic C18 column (100 x 4.6 mm i.d.), maintained at 45 ºC. The mobile phase consisted of acetonitrile and a solution of triethylamine 0.3% pH 5.0 (50:50; v/v), run at a flow rate of 2.0 mL/min, with photodiode array detector set at 213 nm. The chromatographic separation is obtained with PB retention time of 3.4 min, and it is linear in the range of 5-100 μg/mL (r2 = 0.9991). The limits of detection and quantitation are 1.41 and 4.70 μg/mL, respectively. The specificity and stability-indicating capability of the method are proven through degradation studies, which also showed that there is no interference of the formulation excipients, showing that peak is free from any coeluting peak. The method showed adequate precision, with a relative standard deviation values lower than 1.38%. Excellent values of accuracy were also obtained, with a mean value of 100.68%. Experimental design is used during validation to calculate and prove method robustness. The proposed LC method is applied for the analysis of the PB pharmaceutical dosage forms, contributing to improve the quality control and to assure the therapeutic efficacy.

            Downloads

            Download data is not yet available.

            References

            Ikechi, R., Fischer, B.D., DeSipio, J., Phadtare,

            S. Irritable bowel syndrome: clinical

            manifestations, dietary influences, and

            management. Healthcare. 2017; 5(21): 1-14.

            World Gastroenterology Organisation (WGO).

            Global Guidelines Irritable Bowel Syndrome: a

            Global Perspective. Milwaukee, USA, 2015.

            28p.

            Weaver, K.R., Melkus, G.D., Henderson, W.A.

            Irritable bowel syndrome. Am J Nurs. 2017;

            117(6): 48-55.

            Annaházi, A., Róka, R., Rosztóczy, A.,

            Wittmann, T. Role of antispasmodics in the

            treatment of irritable bowel syndrome. World J

            Gastroenterol. 2014; 20(20): 6031-6043.

            Zheng, L., Lai, Y., Lu, W., Li, B., Fan, H., Yan,

            Z., et al. Pinaverium reduces symptoms of

            irritable bowel syndrome in a multicenter,

            randomized, controlled trial. Clin Gastroenterol

            H. 2015; 13: 1285-1292.

            Ramachandra, B. Development of impurity

            profiling methods using modern analytical

            techniques. Crit Rev Anal Chem. 2017; 47(1):

            24-36.

            Kątny, M., Frankowski, M.. Impurities in drug

            products and active pharmaceutical ingredients.

            Crit Rev Anal Chem. 2017; 47(3): 187-193.

            Sahu, P.K., Ramisetti, N.R., Cecchi, T., Swain,

            S., Patro, C.S., Panda, J. An overview of

            experimental designs in HPLC method

            development and validation. J Pharm Biomed

            Anal. 2017; in press.

            Skibinski, R., Trawinski, J. Application of an

            untargeted chemometric strategy in the impurity

            profiling of pharmaceuticals: an example of

            amisulpride. J Chromatogr Sci. 2017; 55(3):

            309-315.

            Holm, R., Elder, D.P. Analytical advances in

            pharmaceutical impurity profiling. Eur J Pharm

            Sci. 2016; 87: 118-135.

            Jandera, P., Hájek, T., Sandra, P. Monolithic

            and core-shell columns in comprehensive twodimensional

            HPLC: a review. Anal Bioanal

            Chem. 2015; 407: 139-151.

            Sangoi, M.S., Todeschini, V., Steppe, M..

            Monolithic LC method applied to fesoterodine

            fumarate low dose extended-release tablets:

            dissolution and release kinetics. J Pharm Anal.

            2015; 5(2): 137-141.

            Ibrahim, F., Wahba, M.E.K. Simultaneous

            liquid chromatographic determination of

            ebastine with two sympathomimetic drugs using

            a monolithic column. J Chromatogr Sci. 2017;

            55(3): 258-266.

            Martins, D.F.C., Florindo, L.C., Machado,

            A.K.M.S., Todeschini, V., Sangoi, M.S.

            Bromide pinaverium: development and

            validation of spectrophotometric methods for

            assay and dissolution studies. J AOAC Int.

            2017; in press.

            International Conference on Harmonization

            (ICH) of Technical Requirements for the

            Registration of Pharmaceutical for Human Use.

            Validation of Analytical Procedures: Text and

            Methodology Q2(R1). Geneva, Switzerland,

            2005. 17p.

            Food and Drug Administration (FDA), Center

            for Drug Evaluation and Research. Guidance for

            Industry: Analytical Procedures and Methods

            Validation for Drugs and Biologics. Silver

            Spring, USA, 2015. 18p.

            Singh, S., Junwal, M., Modhe, G., Tiwari, H.,

            Kurmi, M., Parashar, N., et al. Forced

            degradation studies to assess the stability of

            drugs and products. Trac-Trend Anal Chem.

            2013; 49: 71-88.

            Blessy, M., Patel, R.D., Prajapati, P.N.,

            Agrawal, Y.K. Development of forced

            degradation and stability indicating studies of

            drugs - a review. J Pharm Analysis. 2014; 4(3):

            159-165.

            Lenth, R.V. Quick and easy analysis of

            unreplicated factorials. Technometrics. 1989;

            31: 469-473.

            Downloads

            Published

            28-08-2017 — Updated on 06-03-2026

            Versions

            How to Cite

            Sangoi, M. da S., Machado, A. K. M. da S., Florindo, L. C., Gonçalves, B. R., & Todeschini, V. (2026). Determination of Pinaverium Bromide in pharmaceutical dosage forms by a validated Stability-Indicating LC Method. Drug Analytical Research, 1(1), 38–43. https://doi.org/10.22456/2527-2616.73964 (Original work published August 28, 2017)

            Issue

            Section

            ORIGINAL ARTICLES

            Most read articles by the same author(s)

            Similar Articles

            1 2 3 4 5 6 7 8 9 10 > >> 

            You may also start an advanced similarity search for this article.